Post by Deleted on Mar 3, 2014 10:50:28 GMT -5
I'm going to show for those that are not aware of a tip on how to make a cheap and very useful small sanding block using a piece of plasticstruct square tubing and whatever grit of sandpaper you prefer. I have used this trick for many years.
*First off get yourself some plasticstruct square tubing. It comes in different sizes and follow these tips and you'll have sanding blocks for sanding small items that will last for some time.
* Also when one side wears out, just flip it over and use another side.
* Checkout attached photos of this tip. Good luck!
1. Pick a couple sizes of plasticstruct that suit you.
2. Sand one side of the plasticstruct your using a little flatter then it already is.
3. Get some sand paper and use whatever grit that you suits you.
4. Use super glue, put it on tubing and spread around with a toothpick covering the bottom completely.
5. Lay the plasticstruct down on the sanding block and wait a few minutes.
6. Trim close around the sanding block with exacto knife, being very careful!
7. Homemade sanding block!
